The tickle, the lever position, and the kick sequence that keeps you from flooding it or getting hurt.
We watch people flood Triumphs on the shop floor more often than we watch them start one cleanly. It is almost always the same mistake: too much tickling, wrong throttle position, half a kick instead of a full one. None of it is complicated once you know the order. Here is the order.
Tickling the carb, and when to stop
The tickler on an Amal Concentric is the small pin on top of the float bowl. Press it down and you hold the float open, which lets fuel rise past its normal level and spill into the float bowl, soaking the venturi and giving the engine something to draw on for the first kick. The mistake is holding it too long. Once you see or smell fuel at the overflow pipe, the bowl is full. Let go. Keep pressing and you flood the carb instead of priming it. A flooded cold engine needs the plugs pulled and dried before it will fire.
One or two seconds is usually enough on a bike that has sat overnight. A bike that just ran and is still warm does not need the tickler at all. Tickling a warm engine is the single most common way people flood a hot restart.
The cold start sequence
Fuel on, tickle until you get a trace at the overflow, choke on. Crack the throttle open about an eighth of an inch, no more. A wide open throttle on a cold engine pulls in too much air relative to the fuel you just primed in, and you are back to a weak, lean kick that does not light.
If the bike has a manual advance and retard lever on the handlebar, a magneto-equipped pre-unit for example, retard it fully before you kick. Advance the ignition on a cold start and the spark fires before the piston gets anywhere near top dead center, which is most of what causes a kickback.
Find compression before you commit. Kick through slowly with your hand still on the bars until you feel the resistance build and then ease past it. That is top dead center on the compression stroke. Reset the lever to the top of its stroke, then kick down hard, all the way, in one motion. Once it fires, bring the ignition back to the advance side and start easing the choke off as the engine picks up.
A hot restart is not the same job
A warm engine does not need choke or a fresh tickle, because fuel is already in the intake tract and oil film in the bore is holding compression. Use a smaller throttle opening than you would expect, just barely cracked, with a firm kick through a properly found compression stroke. Most stalled-at-a-light restart failures are the rider flooding a bike that was never lean to begin with, by tickling out of habit and opening the throttle too far.
Why it kicks back
A kickback is the engine firing before the piston has crossed top dead center, which drives the piston and the kickstart lever backward instead of forward. Two things cause it: ignition timing too far advanced for the speed of your kick, or a half-hearted kick that lets the piston hang near top dead center just long enough for the spark to catch it there. Both are avoidable. Retard the ignition if the bike has a lever for it, and once you have found compression, commit to the kick fully. Easing off partway through is exactly how an ankle gets caught.
Find compression first, then commit to the kick. Easing off halfway is how people get hurt.
If a bike that is otherwise in good tune keeps kicking back no matter how careful the kick, stop blaming technique and check the static timing and the valve clearances. A bike timed correctly and kicked correctly does not kick back.

